You can stamp your store logo (or any brand mark) onto every photo Tryon generates — Magic Link try-ons, Showroom shots and Camera Mode results all pick up the same watermark. This article walks through where the setting lives, the image requirements, and every option you can tweak.
Where to find the setting
Open your dashboard and click Settings in the left sidebar. Scroll until you reach the Watermark Settings panel on the right column of the page.
Flip the Add watermark toggle on to expose the upload area and the position, anchor and opacity controls.
Image requirements
- Format: PNG with a transparent background.
- Recommended width: 300 px.
- Maximum width: 700 px.
Why PNG with transparency
The watermark is composited on top of the generated photo. Any solid background in the image will show as a rectangle on the final result — so the file must be a transparent PNG.
Uploading the watermark
Click the dotted Upload watermark image area and pick the PNG from your computer. Once it uploads, a thumbnail labelled Current watermark appears, with a Change image link below it if you want to swap the file later. The small × button to the right removes the current watermark without disabling the feature.
Position and anchor
Two dropdowns control where the watermark sits on the generated photo:
- Position (vertical) —
Top,MiddleorBottom. - Anchor (horizontal) —
Left,CenterorRight.
Combining the two gives you nine placement options. The most common choice is Bottom + Right, which keeps the watermark visible without covering the model.
Opacity
The Opacity slider sets how transparent the watermark looks on the final photo, from 0% (invisible) to 100% (fully opaque). Around 50–60% is a good starting point — it's readable but doesn't dominate the image. Slide higher for a stronger brand presence, or lower for a subtle stamp.
Using the preview
Click Preview - See how your image will look (right below the watermark thumbnail) to open a modal that overlays your current watermark on a sample try-on photo, using the position, anchor and opacity values you've set. Tweak the controls and reopen the preview as many times as needed until you're happy with the result.
Saving
None of these changes take effect on real generations until you click Save Settings in the bottom-right corner of the page. After saving, every new try-on photo will include the watermark you configured.
Previously generated photos are not re-rendered when you change the watermark. The new settings only apply to images created from that point onward.
Turning it off
Flip the Add watermark toggle back off and click Save Settings to stop adding the watermark to new photos. Your uploaded file stays on record, so you can re-enable the feature later without uploading it again.